Cone Crusher different parts have different lubrication requirements

Good lubrication can guarantee the normal life of the cone crusher, effectively reducing the friction between the parts, we need to note that the cone crusher lubrication requirements of different parts is not the same, too much or too little will affect the life of the equipment and efficiency, the following Zhongxin will give you a brief introduction of the spring cone crusher lubrication requirements.

Spring cone crusher support sleeve is generally saw type thread, and the liner was screwed into the thread by rotating around the ring to adjust the size of the mine discharge port, because of its shape thread lubrication caused more complex, so often artificial lubrication, this can effectively ensure good lubrication components.

For lubrication spring cone crusher eccentric, spherical bearings and gears, the need to use thin oil circulation lubrication way, such lubrication is sucked from the mailbox main shut-off valve to the pump through the lubricating oil in through the filter, from two a shutoff valve into the cooler to form a two-way, flow through the gap clearance bevel gear shaft and the lower portion of the eccentric bushing and the eccentric bushing cone and straight between the liner and then back to the tank.

These are technical engineers Zhongxin lubricated parts against common method proposed, if you are experiencing problems in other lubricating actual production use, you can inquire us.

Pre: The working characteristics of jaw crusher

Next: How to reduce the cost of jaw crusher technology